NSF 456 CERTIFIED VACCINE FREEZERS Models: VT65MLVAC456 VT65MLVAC456ADA User Manual BEFORE USE, PLEASE READ AND FOLLOW ALL SAFETY RULES AND OPERATING INSTRUCTIONS Write Model and Serial Numbers here: Model: _____________________ Serial No.: __________________ Accucold Division of Felix Storch, Inc. An ISO 9001:2015 registered company 770 Garrison Avenue Bronx, NY 10474 www.accucold.
EQUIPMENT SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your unit. Always read and obey all safety messages. This is the Safety Alert Symbol. The symbol alerts you to potential hazards that can kill or injure you and others. All safety messages will follow the Safety Alert Symbol and either the words "DANGER" or "WARNING".
• • • • • • • • • • • • The unit should not be located next to ovens, grills or other sources of high heat. The unit must be installed with all electrical, water and drain connections in accordance with state and local codes. A standard electrical supply (115 V AC only, 60 Hz), properly grounded in accordance with the National Electrical Code and local codes and ordinances, is required. Do not kink or pinch the power supply cord of the unit. The size of the fuse (or circuit breaker) should be 15 amperes.
TABLE OF CONTENTS Equipment Safety 2 Important Safeguards 2-3 Technical Information 5 Installation Instructions 6-9 Before Using your Freezer 6 Installing the Freezer 6 Stabilization Period 6 Electrical Connection 7 Reversing the Door Swing 7 Door Handle Installation 7 Operating your Freezer 8- Digital Thermostat 8 Temperature Monitoring Device (TMD) 9-10 Storage 10 Defrosting 10 Care and Maintenance 11 Cleaning your Freezer 11 Power Failure 11 Vacation Time 11 Moving y
TECHNICAL INFORMATION Model Number Color Capacity VT65MLVAC456 VT65MLVAC456ADA White Gross capacity 3.2 cu. ft. Useable interior capacity 1.85 cu. ft. Electrical Input 115V AC/60 Hz Rated Current 1.3A Temperature Setpoint Refrigerant Installation Unit Dimensions (H x W x D) -30°C R134a (2.7 oz) Built-in or Free-standing Built-in or Free-standing 33.5” to 34.5” x 23.63" x 23.5" 32.0” x 23.63" x 23.
INSTALLATION INSTRUCTIONS Before Using your Freezer • • Remove the exterior and interior packing. Check to be sure you have all of the following parts: o 3 drawers o Calibration certificate o 1 short drain tube o 2 keys CAUTION: After unpacking you MUST allow this appliance to stand upright for at least 2 hours to allow the lubricant and refrigerant to drain back into the compressor and stabilize. Failure to do so may adversely affect performance and the lifetime of your unit.
Electrical Connection Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is damaged, have it replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard. This unit should be properly grounded for your safety. The power cord of this unit is equipped with a three-prong plug that mates with a standard three-prong wall outlet to minimize the possibility of electrical shock.
OPERATING YOUR FREEZER NOTE: If the unit is unplugged, has lost power, or is turned off, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the freezer will not start. Digital Thermostat Your freezer is preset to -30 ºC. If you find it necessary to change the temperature setting for your digital thermostat follow the instructions below. To change the SET POINT • To prevent accidental adjustment, the thermostat is locked.
state’s health department guidelines). For more information on how to have your device re- calibrated or to replace a valid certificate, contact us at calibration@summitappliance.com. The temperature sensor, or probe, is enclosed in a glycol-filled bottle that is stored inside your unit in a special compartment. Function of Controls RESET Key: Press and hold to reset Max/Min temperature history. ALARM ON/OFF: Press for 2 seconds to turn the alarm feature ON/OFF.
Storage Store vaccines and other frozen items in any of the three drawers, below the loading line. NOTE: Be sure to store all items below the top of the baskets within each shelf. Defrosting The appliances require manual defrosting. The appliance is equipped with a defrost indicator. It is located above the top drawer. For optimal performance, the freezer should be defrosted when the defrost indicator is no longer visible, when approximately ¼” of ice has formed inside the cabinet.
CARE AND MAINTENANCE Cleaning your Freezer CAUTION: Failure to unplug the unit before cleaning can result in electrical shock or personal injury. 1. Unplug the freezer and remove the frozen items and drawers. 2. Wash the inside surfaces with a solution of lukewarm water and vinegar. Wipe dry with a clean, soft cloth. 3. Wash the drawers with a mild detergent solution, then rinse and dry thoroughly. 4. Wash the outside cabinet with warm water and mild liquid detergent.
TROUBLESHOOTING When using the freezer, you may come across some problems that in many cases result from improper handling of the appliance and can easily be eliminated. The appliance fails to operate after being connected to the power source. Check whether the power supply is active and that the (manual) thermostat is not set to the stop position. The red light is on (manual thermostat), or unit is not cooling properly (digital thermostat). The door was opened frequently, or it was left open too long.
LIMITED WARRANTY TWO-YEAR LIMITED WARRANTY Within the 48 contiguous United States, for two years from the date of purchase, when this unit is operated and maintained according to instructions attached to or furnished with the product, warrantor will pay for factoryspecified parts and repair labor to correct defects in materials or workmanship. Service must be provided by a designated service company. Outside the 48 states, all parts are warranted for two years from manufacturing defects.
CONSIGNES DE SÉCURITÉ Votre sécurité et celle des autres est très importante. Nous avons fourni de nombreux messages de sécurité importants sur votre appareil dans ce manuel. Toujours lire et respecter les consignes de sécurité. Ceci est un symbole d'alerte de sécurité. Ce symbole vous signale les dangers qui pourraient tuer or blesser vous et les autres. Tous les messages de sécurité suivront le symbole d'alerte de sécurité, soit après le mot "DANGER" ou "AVERTISSEMENT".
• • • • • • • • • • • • • L'appareil ne doit pas être situé à proximité de fours, grilles chauffantes ou d'autres sources de chaleur élevée. L'appareil doit être installé avec toutes les connexions électriques, d'eau et de vidange conformément aux codes nationaux et locaux. Une alimentation électrique standard (115 V CA seulement, 60 Hz), correctement mise à terre en conformité avec le National Electrical Code et les codes et ordonnances locaux, est requise.
INFORMATIONS TECHNIQUES Numéro demodèle Couleur Capacité Entrée électrique VT65MLVAC456 VT65MLVAC456ADA Blanche Capacité totale 3.2 cu. ft. Capacité intérieure utile 1.85 cu. ft. 115V AC/60 Hz Ampérage 1.3A Température interne la plusfroide Refrigérant Installation Dimensions de l’unité (Ha x La x Pr) -35°C R134a (2.7 oz) Intégré ou Sur Pied Intégré ou Sur Pied 33.5” to 34.5” x 23.63" x 23.5" 32.0” x 23.63" x 23.
INSTRUCTIONS D’INSTALLATION Avant d'utiliser votre congélateur • • Retirer l'emballage extérieur et intérieur. Vérifiez que vous avez toutes les pièces suivantes : o 3 tiroirs o Certificat d'étalonnage o 1 tube de drainage courte o 2 clés ATTENTION : Après le déballage vous DEVEZ permettre votre appareil de se tenir debout pendant au moins 2 heures pour permettre aux lubrifiant et réfrigérant à écouler dans le compresseur et se stabiliser.
Connexon électrique AVERTISSEMENT Une mauvaise utilisation de la prise de terre peut entraîner un risque de choc électrique. Si le cordon d'alimentation est endommagé, le faire remplacer par le fabricant, son agent de service ou une personne qualifiée afin d'éviter un danger. Cet appareil doit être correctement mis à la terre pour votre sécurité.
FONCTIONNEMENT DE VOTRE CONGÉLATEUR REMARQUE : Si l'unité est débranchée, a perdu l'alimentation ou est éteinte, vous devez attendre 3 à 5 minutes avant de redémarrer l'unité. Si vous essayez de redémarrer avant ce délai, le congélateur ne démarrera pas. Thermostat numérique Votre congélateur est préréglé à -30ºC, avec une plage de -25º à -35ºC. Si vous jugez nécessaire de modifier le réglage de la température de votre thermostat numérique, veuillez-vous référer aux instructions suivantes.
Votre appareil est équipé d'un appareil de mesure de la température (TMD) étalonné par le NIST, également appelé thermomètre/alarme, qui affiche simultanément les températures intérieures minimale, maximale et actuelle et fournit un signal visuel et sonore lorsque la température à l'intérieur de l'appareil tombe en dehors de la plage de température définie. REMARQUE : Lorsque vous recevez votre congélateur pour la première fois, le TMD-02 est éteint. Il devra être allumé avant utilisation.
Si la température monte au-dessus ou tombe en dessous de la plage de température définie, l'alarme émet un bip sonore et l'indicateur HI-ALARM/LO-ALARM sur l'écran clignote jusqu'à ce que la température revienne dans la plage. Pour arrêter l'alarme, appuyez sur n'importe quel bouton. Le bip sonore dure 60 secondes, mais les indicateurs haut et bas restent affichés même lorsque l'appareil revient à portée.
SOINS ET ENTRETIEN Nettoyage de votre congélateur ATTENTION : Ne pas débrancher l'appareil avant le nettoyage peut entraîner un choc électrique ou de blessure. 1. Débranchez le congélateur et supprimer les éléments et les tiroirs congelés. 2. Lavez les surfaces intérieures avec une solution d'eau tiède et de vinaigre. Essuyer avec un chiffon doux et propre. 3. Laver les tiroirs avec une solution de détergent doux, puis rincer et sécher complètement. 4.
DÉPANNAGE Lorsque vous utilisez le congélateur, vous pouvez rencontrer certains problèmes qui dans de nombreux cas peuvent résulter d'une mauvaise manipulation de l'appareil et peuvent être facilement éliminés. L'appareil ne fonctionne pas après avoir été connecté à la source d'alimentation.
Vérifiez si l'alimentation est active et que le thermostat (manuel) n'est pas en position d'arrêt (stop). La lumière rouge est allumée (thermostat manuel), ou l'unité ne refroidit pas correctement (thermostat numérique). La porte a été ouverte fréquemment ou elle a été laissée ouverte trop longtemps. La porte est mal fermée (la porte peut s’affaisser ; le joint peut être sale ou endommagé). L'alimentation électrique a été interrompue pendant une longue période.
GARANTIE LIMITÉE UN AN DE GARANTIE LIMITÉE Dans les 48 États américains contigus, pendant un an à partir de la date d'achat, lorsque cet appareil est utilisé et entretenu conformément aux instructions jointes à, ou fournies avec le produit, le garant paiera pour les pièces spécifiées en usine et pour la main-d’œuvre pour corriger les vices de matériaux ou de fabrication. Le service doit être fourni par une compagnie de service désignée.