User Manual

3.3. Animal weighing function
Set the value into 2 in the P9 of the system setting then the animal weighing function will be
switched on. Set the value into 1,the animal weighing function will be switched off.
3.4. Accumulating function
In weighing state, press key to accumulate the current weight, when the weight is over
20e and the weighing data is stable. And the accumulating light is lightning. When pressing
key again, it will return the weighing mode. And the accumulating light will be off. It will show
current accumulating value when pressing the key under the zero point state. In accumulating
sate, press key to clean the accumulating value .When press the key again, it will return
to weighing mode again also. And the accumulating light will be off.
Note: the scale must zero before next accumulation operation. otherwise it can not perform the
second time accumulating operation.
3.5. Counting function
In weighing mode, long press key and hold on it to enter the counting mode. The counting
light will be lightning. And it will display 【Count 】. When it is stable, press key to enter
sampling numbers setting and it display 【C00000】. Press key to shift after putting some
samples on the scale platform. Press key to set the sample numbers value. After setting the
value of the current sample number, Press key to perform the sampling and it display
【------】. When it show number, it means you can operate the counting now. This time sampling
date will be saved. Press key to exit the counting mode.
Note:
If the sample weight is smaller than the minimum sampling weight, the sampling will be
failed. It will grab the previous sampling data.
If the sample unit weight is smaller than the minimum sampling unit weight, the sampling
will also be failed. It will also grab the previous sampling data.