Installation Guide

ManualsBrandsACHIM ManualsBlindsGII Morningstar Black Cordless Light Filtering Vinyl Mini Blind with 1 in. Slats 34 in. W x 48 in. L

Achim Home Décor’s Family of Home

Furnishings thanks you for your most recent

purchase. We are confident this product will

bring beauty and functionality to your home.

Installation Instructions for Cordless GII

Morningstar 1-in Light Filtering Mini Blind

Time to complete:

Approximately 15 minutes

Tools needed:

Pencil, tape measure, level, Phillips screwdriver,

drill, and 3/32-in drill bit

In the box (images are not to scale):

1 – Cordless GII Blind with tilt wand

2 – Brackets

8 – Screws

Important Safety Information

Please read all instructions, warning tags and labels provided with your new

product. Proper installation and operation are essential to avoid injury.

Keep these instructions for future reference.

Achim Home Décor: 1-800-54-ACHIM

Customerservice@achimonline.com

Summary of content (5 pages)

PAGE 1
Achim Home Décor’s Family of Home Furnishings thanks you for your most recent purchase. We are confident this product will bring beauty and functionality to your home. Installation Instructions for Cordless GII Morningstar 1-in Light Filtering Mini Blind In the box (images are not to scale): 1 – Cordless GII Blind with tilt wand 2 – Brackets 8 – Screws Important Safety Information Please read all instructions, warning tags and labels provided with your new product.
PAGE 2
Installation Instructions for Cordless GII Morningstar 1-in. Light Filtering Mini Blind Step 1 – Determine mounting type: inside, ceiling or outside x 1. 2. x x x 3. There are three options for hanging: 1. Inside mount will allow the blind to fit inside the window frame and will be installed using the bracket’s top screw holes into the underside of the window frame. 2. Ceiling mount will allow the blind to hang in front of the window frame from the ceiling and will use the bracket’s top screw holes.
PAGE 3
Installation Instructions for Cordless GII Morningstar 1-in. Light Filtering Mini Blind Step 4 – Mark the screw locations Using the brackets in the below pictured position, mark screw locations within the acceptable area of your previous markings and/or measurements. x x x x **Bracket images enlarged to show detail** See above images: For inside mount and ceiling mount use bracket’s top screw holes. See above image: For outside mount use the bracket’s back screw holes.
PAGE 4
Installation Instructions for Cordless GII Morningstar 1-in. Light Filtering Mini Blind Step 7 – Mount blind into brackets With the blind fully retracted and the top of the blind’s headrail angled towards the window, align the front of the headrail to the top and front portion of the bracket, labeled “A” below. Then, rotate the headrail and blind towards the window until you hear a click, labeled “B” below.
PAGE 5
Installation Instructions for Cordless GII Morningstar 1-in. Light Filtering Mini Blind Troubleshooting: BOTTOM RAIL IS UNEVEN: Raise the blind to the top and lower the blind using center of the bottom rail. Lower the blind to approximately 3 ft from the headrail. While holding one side of the bottom rail, adjust the other side of the headrail as needed to align. Raise and lower from the center of the bottom rail twice to check consistency and repeat above steps, if necessary.