Owner manual

ARTEX PRODUCTS / ACR ELECTRONICS, INC.
DESCRIPTION, OPERATION, INSTALLATION AND MAINTENANCE MANUAL
453-6500
25-69-10
Page 44 of 58
APR 30/12
(3) Align the ELT/NAV Interface on the mounting structure.
(4) Mark the six holes needed for mounting, using the unit as a pattern. Hole pattern dimensions
are also illustrated in "Figure 6. ELT/NAV Interface Outline and Dimensions”, on page 43.
(5) Drill the six mounting holes with a #19 or 4.25 mm drill.
(6) Install the ELT/NAV Interface chassis with the 8-32 x 5/8” SS pan head phillips screws, flat
washers, lock washers, and nuts provided in the installation kit (455-6500), as shown in
"Figure 7. ELT/NAV Interface Mechanical Installation".
NOTE
: The use of substitute mounting hardware is acceptable provided the hardware used
meets or exceeds the strength and corrosion resistance of the original hardware.
(a) Torque to 12 ±1 lb-in (136 ± 11 N•cm).
Figure 7. ELT/NAV Interface Mechanical Installation
ELT/NAV
INTERFACE
ELT (REF.)
MOUNTING
STRUCTURE
(REF.)
SCREWS
(6 PLCS)
FLAT WASHER (6 PLCS)
LOCK WASHER (6 PLCS)
HEX NUT (6 PLCS)