Owner manual

ACR ELECTRONICS, INC / ARTEX PRODUCTS
DESCRIPTION, OPERATION, INSTALLATION AND MAINTENANCE MANUAL
G406-4 (453-5012)
25-62-21
Page 58 of 86
JUL 31/12
(2) Locate the mounting tray such that the ELT mounting frame cap has at least 5 inches (127
mm) of clearance for installation and removal.
(3) Mount the ELT as far aft as practical, but where it can be easily retrieved for maintenance.
NOTE
: Statistics show that the tail section of an airplane is likely to be less damaged during
a crash; therefore, providing a good mounting environment for the ELT.
(4) Additional installation guidance may be found in AC 43.13-2, Chapter 2, Paragraph 28, which
specifically addresses ELT installations.
SUBTASK 25-62-21-450-002
B. Installation
(1) See "Figure 13. Typical Mounting Tray Installation".
Figure 13. Typical Mounting Tray Installation
(2) Install the necessary mounting structure as appropriate for the specific installation.
(3) Align the mounting tray (452-0227) on the mounting structure, such that the arrow on the
tray is within 10° of the longitudinal axis of the aircraft and pointing in the direction of flight.
(4) Mark the four holes needed for mounting the tray, using the tray as a pattern. The hole
pattern is also illustrated in "Figure 12. G406-4 ELT Outline and Dimensions”, on page 57.
(5) Drill the four mounting holes with a #19 or 4.25 mm drill.
8-32 x 5/8 SCREW
(4 PLCS)
#8 FLAT WASHER
(4 PLCS)
#8 LOCK WASHER
(4 PLCS)
8-32 X 1/4 HEX NUT
(4 PLCS)
AIRFRAME
STRUCTURE (REF.)
EQUIPMENT MOUNTING
PLATE (REF.)
MOUNTING
TRAY