Specifications

Y1-03-0138 Rev. H

Wiring to Power Supply

The power source must be a fused 12 VDC, 10-amp supply or 24 VDC, 5-amp supply.

Following the wiring scheme in Table 1, use the supplied butt connectors to connect the Master

controller to the Power Source. Refer to Table 2 for proper wire size for connection of the

input power lines.

NOTE: As per the wiring scheme, the ORANGE wire is connected to the Positive terminal

and the BLUE wire is connected to the Negative terminal of the power source.

NOTE: Observe polarities when attaching wires!

Maximum Cable Length

Wire Size 12v System 24v System

#8 AWG 25 ft. 100 ft.

#10 AWG 15 ft. 60 ft.

#12 AWG 10 ft. 40 ft.

Table 2

Function

The URC-102 Master Controller is designed to perform up to six different duties on

searchlights, winches, and other electrical devices. The Master Controller provides optimum

voltage to ensure brightest performance and long lamp life, regardless of boat system voltage

fluctuations. The Master Controller is compatible with devices requiring 12 VDC or 24 VDC

operation.

The URC-102 Master Controller has the unique XRCiZ feature. The XRCiZ feature routinely

operates all moving parts in the Searchlight to keep the motors and drive mechanism freely

running. Once activated, and every 30 days thereafter, the XRCiZ feature wakes up and

operates the Searchlight. The Searchlight will rotate 360° in both directions and the parabolic

reflectors will move to the full up and down positions. This feature keeps the Searchlight in

peak working order when not in service for long periods of time.

To activate the XRCiZ feature, press and hold the Point Pad™ ON/OFF button for greater than

5 seconds. The Green LED on the URC-102 Point Pad™ indicates that the XRCiZ feature is

enabled. While enabled, The XRCiZ feature can be started outside of its 30-day cycle by

pressing and holding the Speed button on the Point Pad™ for greater than 5 seconds.

While the XRCiZ feature is operating the Searchlight, pressing any Point Pad™ button will

stop the current cycle and leave the Searchlight to follow any additional commands.

To deactivate the XRCiZ feature, press and hold the Point Pad™ ON/OFF button for greater

than 5 seconds. The Red LED on the URC-102 Point Pad™ indicates that the XRCiZ feature is

disabled.

NOTE: LED feedback is not available when using RCL-100 or URC-101 Point Pads™.