Specifications

Y1-03-0138 Rev. H
15
8.0 BULB REPLACEMENT
Two 55W, quartz-halogen bulbs are provided with your RCL-100D. If they should need
replacement, they must be ordered through ACR Electronics, by P/N A1-14-0080-1 (12V units)
or A1-14-0080-2 (24V units).
To replace the lamps:
1. Disconnect unit from power source and allow bulbs to cool.
2. Remove two screws holding the front flange and glass in place.
3. To remove the old lamp bulbs, grasp base of the lamp and pull straight out. DO NOT
TOUCH GLASS PARABOLIC REFLECTORS WITH FINGERS OR TOOLS!
4. Install the new lamp bulb using a soft clean cloth to avoid touching the bulb with your
fingers. Insert the lamp bulb pins into socket and press firmly in place.
NOTE: If the Lamp Bulb or Reflectors are accidentally touched, carefully clean with
a soft rag and alcohol before continuing.
5. Replace the front flange and glass and install the two retaining screws. Be sure the
neoprene gasket is securely in place.
6. Reconnect the unit to the power source.
9.0 RCL-100D SEARCHLIGHT COMPONENTS
PRODUCT NO. 1930.3 - RCL-100D 12 V Searchlight Installation Kit includes:
Description Quantity ACR Part Number
Searchlight, RCL-100D, 12 V 1 A3-06-1106-3
Kit, Nylon Washers (4) 1 A3-06-1940
Connector, “F” 2 A1-03-0220
Cable, Coaxial 15' A2-07-0002-6
Master Controller, URC-102 1 A3-06-2231
Connector, "In-Line" 8 A1-03-0222
Point Pad™, URP-102 with
Surface Mount Case 1 A3-06-2230
Case, Flush Mount 1 A1-18-1875-2
Gasket, Surface Mount 1 A1-25-0140-1
Gasket, Flush Mount 1 A1-25-0140-2
U Clamp 2 A1-17-1366
Nuts, Nylon-lock 2 A1-05-0776
Washers 2 A1-05-0777
Warranty Card 1 A1-20-1019
Product Support Manual 1 Y1-03-0138
Mounting Templates 1 Y1-03-0138-1
Troubleshooting and
Maintenance Guide Instructions 1 Y1-03-0137