user manual

Machine-Side Hopper Loaders
4-6 Assembly instructions
4.4.1. Mounting on the processing machine
A VT Series adapter is required to mount the
loader on the processing machine. Two-liter
models require a VT 1.0 adapter. Five-liter
models require a VT 2.3/70 or VT 2.8/70
adapter. Use the following procedure to mount
the loader to the processing machine:
1. Mount the VT Series adapter onto the flange
of the processing machine.
2. Mount the loader onto the adapter.
F Observe the bearing capacity of the machine flange.
4.4.2. Mounting onto a machine hopper
Two-liter models require an EF 190 welding flange for mounting onto a machine hopper.
Five-liter models can be mounted to a machine hopper using either the EF 253 welding
flange or the MF 253 assembly flange.
Using the EF Series Welding Flange:
L Please observe all safety regulations for the
operation of welding equipments.
Always wear safety goggles.
1. Weld the welding flange into the machine hopper lid.
2. Mount the loader onto the welding flange.
Using the MF Series Assembly Flange (Five liter models
only)
1. Mount the assembly flange into the machine hopper lid.
2. Mount the loader onto the assembly flange.
Figure 5: VT Adapter
Figure 6: EF Welding Flange
Figure 7: MF Assembly Flange