user manual

Machine-Side Hopper Loaders
4-10 Assembly instructions
Connecting Material Lines:
Component 1 – connected to the intake port furthest from the air cylinder (regrind)
Component 2 – connected to the intake port closest to the air cylinder (virgin)
Setting the ratio:
When the loader motor is not running, pressing the arrow key on the valve’s controller
will change the percentage of component 1. This can be set from 0% to 99%
Set the cycle switching:
Press and hold the percentage key on the valve’s controller. Then by pressing the up
arrow, you will be selecting the cycle time period in increments of 5 sec.
For example, if the convey time is 60 seconds and you select a cycle time period of 10
sec. the valve will switch a total of 6 times.