User Manual

www.acti.com
Hardware Manual
17
Step 3: Route the Cables
Determine whether the cable will pass through a hole on the surface or be routed along the
surface:
If the cable will pass through a hole on the surface:
1. Drill the hole for the cable on the surface.
2. Route the cable from the network side through the hole and connect it to the Ethernet port of
the camera.
NOTE: If the camera will be installed outdoors or in places wherein environmental factors
change drastically, make sure to waterproof the cable connection; see Step 5: Waterproof
the Cable Connection on page 19 for instructions.
3. Push the cable through the the hole on the surface.
If the cable will be routed along the surface
1. Pull the tab to slide it off from the dome cover.
2. Route the camera cable through the gap on the camera cover.
Drill cable hole
within this block.