Instructions / Assembly

Read All Directions Carefully Before Starting Work
This Storm Shield
®
Threshold Kit has been developed to make
the job of installation as simple as possible. However, certain
procedures are critical, be sure every step is completed before
starting. Storm Shield
®
must be applied to clean, dry, concrete
at temperatures above 40°F (5°C). It is unnecessary to remove
existing weatherstrip from door bottom. Not recommended for
use on asphalt, painted or treated surfaces, broken concrete or
gravel.
Tools You Will Need
All materials are supplied in the kit. You will need a tape measure,
a utility knife and a pencil. Use adhesive included.
Fitting the Threshold
1. With the garage door open, center threshold between the
garage door track (the channel the door rollers ride in) (A).
Trim length if necessary.
2. Now lower the garage door down on top of the Threshold’s 2
inch (5cm) flap (B). Push the 45° hump against the back of the
bottom of the garage door for proper seal. The 45° hump must
be to the inside of the garage door. (Notch Threshold around
door jambs if necessary.) Trace the inside edge with a pencil.
Carefully raise the door and trace the outside of the Threshold (C).
3. Remove the Threshold and apply 3 rows of adhesive as shown
(D): two continuous rows 1/4 inch (.65cm)inside of the pencil
lines, the third row in a zigzag pattern between the others. Place
the Threshold between the pencil lines and press into place.
Carefully apply pressure to the Threshold to spread the adhe-
sive uniformly. Make sure the Threshold is still between the
lines and correct if necessary.
EXCLUSIVE FULL 2 YEAR WARRANTY
The manufacturer guarantees a full 2 year residential
warranty on all Storm Shield
®
Threshold and adhesive
materials for two years from the date of original purchase,
when this Garage Door Threshold Kit is installed and
maintained according to our instructions. The manufacturer
will replace any Storm Shield
®
Threshold or Adhesive free
of charge if found defective in material or workmanship.
(Replacement of material does not include cost of installation.
Original receipt required.)
This warranty gives you specific legal rights, you may also
have other rights which may vary from state to state. This
warranty applies to normal residential use only.
Warranty Service is available in the United States by
contacting the establishment where you purchased the
product.
The
Original
Garage
Door
Threshold
4. Close door and keep constant pressure on the Storm Shield
®
,
allowing a minimum of 24 hours for the adhesive to dry before
driving over it.
NOTE: It may be necessary to adjust the garage door side locks or
the electric garage door opener due to a change in the
door’s position. Please refer to your original
manufacturer’s guidelines for these procedures.
GARAGE DOOR THRESHOLD
StormShield
INSTALLATION INSTRUCTIONS:
®
ABCD
Front
(Outside)
2” (5cm) flap
45° hump
Back
(Inside)
11353 Instruction sheets AC1 11/6/01 6:34 PM Page 2