Owner's manual

PROGRAMMING
MILLPWR
Page 3-4 Operation Manual
Creating a Program
Press the PGM key, and the following program screen appears.
You create a program by creating a list of milling steps to be performed. As you add to
your list, each step will be drawn immediately on the screen so you can see a picture
of your part in progress.
• To enter a milling step, press the appropriate milling function key. The function
you select will appear in the program listing, and you can enter the information
SERVO OFF
FEED 0 100%
INCH
SCALE 1.0000TOOL:
PROGRAM
FUNCTIONS
CLEAR
PROGRAM
EXPLODE
MORE
STEPS
RUN
OPTIONS
CURRENT PROGRAM
END OF 0
Enter
information
about the arc
into this form.
Program
Step
Listing
SERVO OFF
FEED 0 100%
INCH
SCALE 1.0000TOOL:
TEACH
POSITION
MOREPOLAR
CURRENT PROGRAM
2 OF 2
001 SET TOOL
MILL ARC 002
TO
X2 ABS
Y2 ABS
RADIUS
DEPTH
Z ABS
DIRECTION
CCW
FROM
X1 ABS
Y1 ABS
TOOL
0.500 DIAMETER
FL END ML
TYPE
10FEED IPM
CENTER OFFSET
002 MILL ARC X