Owner's manual

PROGRAM STEPS
MILLPWR
Page 5-6 Operation Manual
Face
This step provides a quick way to face off a workpiece. Enter
the CENTER location and the SIZE of the area to be faced.
MILLPWR will start at the lower left of the area and zigzag
upwards.
The MORE softkey brings up fields to let you TILT the face
rectangle, and to change the tool STEPOVER.
FACE 001
SIZE
IN X
IN Y
DEPTH
0.0000Z ABS
CENTER
X ABS
Y ABS
TOOL
INCH
TYPE
10FEED IPM
TILT ANGLE
FINISH
STEPOVR %
0° 00' 00"
SERPENTINE PATH
(NO TOOL OFFSET)
SIZE IN X
SIZE IN Y
STEP-
OVER