HM1 Home Monitor Operation manual english english / deutsch
Introduction First of all, we would like to thank you for choosing ADAM Audio! ADAM Home Monitors are built for maximum quality reproduction and audio perfection. You have selected a precise, high resolution passive speaker system that allows you to professionally evaluate audio recordings. We are confident that these monitors can meet your expectations for faithful sound reproduction.
Setting up your speakers General recommendations for the set up: The speakers should be positioned on firm ground or a stand. Vibrating parts of nearby objects can mask the sound. Normally it is advised to set them up in the vertical position: Horizontal placement is possible. Please position both tweeter sections either to the outside or to the inside. You will get the best linear frequency response from different listening positions. Obstacles between the speaker and your ear must be avoided.
Setting up your speakers The Tweeter should be positioned approximately at the height of your ears. In case you need to position the speaker in a significant lower or higher position, the monitor should be angled accordingly. Placement of 2 speakers The ideal placement of two speakers and a listener in a two-channel stereo listening situation are the corner points of a equilateral triangle (60° angles).
A.R.T. Accelerated Ribbon Technology So far, all loudspeaker drive units, whether they are voice coil driven, electrostatics, piezos or magnetostatics, act like a piston, moving air in a 1:1 ratio. As the specific weight of air is much lower than that of the driving mechanics, there is a bad match between source and load. This is one of the main reasons for the small 1-2% efficiency of conventional speakers.
Warranty ADAM Audio GmbH provides a ten year limited warranty for this product. Terms and Conditions This warranty is limited to the repair of the equipment or, if necessary, the replacement of parts or the product and return shipping within the country of purchase. This warranty complements any national/regional law obligations of dealers or national distributors and does not affect your statutory rights as a customer.
HM1 Front HM1 Back A.R.T. Tweeter ). 5“ HexaCone® woofer Tweeter level switch: l= 0 0= -1.5dB l 0 ll ll= +1.5dB Speaker terminal Bass reflex port (2x) Technical Data Woofer/Subwoofer 1 General Data Basket ø 6” / 156 mm Freq. response 45Hz - 35kHz ART Tweeter 1 SPL max at 1m ≥ 103dB Velocity transf. ratio 4:1 Crossover frequencies 2200Hz Input terminal Biwireing Input impedance 4Ω Controls Tweeter level* 0/-1.5dB/+1.
ADAM Audio GmbH Ederstr. 16 12059 Berlin GERMANY tel: +49 30-863 00 97-0 fax: +49 30-863 00 97-7 email: info@adam-audio.com ADAM Audio UK Ltd. email: uk-info@adam-audio.com ADAM Audio USA Inc. email: usa-info@adam-audio.com ADAM Audio China email: sales@adam-audio-china.com www.adam-audio.