Product Manual

17 | P a g e © Adam Equipment Company 2010
• The number of decimal points will depend on the weight used in comparison
to the capacity of the system. A smaller weight will show only “100%” while a
larger weight might show “100.00%”.
• If the scale was showing zero weight when entering this function, then the
user must manually enter the weight to be set as 100% as described below.
• Press the [Z/T] key. “P1 PCt” will be displayed.
• Press [Z/T] again to enter percent weighing. The scale will now accept a value
the user enters as the reference weight.
• Enter the value using the [Unit/

] key and [Pcs/

] key to set the values of
the 100% mass.
• When set press the [Z/T] key to store the value. The display will show “0.00
%”.
• The weight entered must be greater than 50 scale divisions.
• Press [Unit/

] to return to weighing.
NOTE:
The display may jump by large numbers unexpectedly if small weights are used to
set as 100% reference. The scale checks if the weight is too small and will show
Error 7.