User's Manual

20 © Adam Equipment Company 2013
temperature of the water, selections are either using the automatic temperature
sensor or to manually input the temperature.
If another liquid is used then the user must set the density of that liquid.
The display will show Liquid, Press [Tare] to enter this section.
Press [Air/Liquid] or [Density] to select H2O or Define den. Press [Tare] to select the
setting or press [Unit/Clr] to return to the Liquid display.
If H2O is selected the display will show the current setting for the temperature
determination, either Auto tmp, or Set tmp.
Press [Air/Liquid] or [Density] to select the option, then press [Tare] to store the
selection.
If Auto tmp is selected the display will show the current temperature measured by
the external temperature probe. Press [Tare] to accept the value and return to
Liquid.
If Set tmp was selected the display will show the temperature last set by the user i.e.
24 °C tmp . To change the current setting press the [Air/Liquid] or [Density] key to
increase or decrease the value. Press [Tare] when the correct value is shown.
The display will return to show Liquid. Press [Unit/Clr] to return to weighing or press
[air/Liquid] or [Density] to change the display to set the Alloy parameters.
If Define den was selected for setting the density of another liquid press [Tare] and
the display will show the current valued stored. Enter the value for the density of
the liquid you are using (in g/cc
3
) by using the [air/Liquid] or [Density] keys to
change the value of the flashing digit on the display, and the [Hold/Print] key to
change the flashing digit position. Press [Tare] when the correct value is shown.
The display will return to show Liquid. Press [Unit/Clr] to return to weighing or press
[air/Liquid] or [Density] to change the display to set the Alloy parameters.
6.4 ALLOY PARAMETERS
If Gold (Au) has been selected for the alloy to test the balance will compute the
density based on the weight values recorded. The value for purity (karats) and
content will be computed depending on the alloy selected by the user. The alloy