User's Manual

21 © Adam Equipment Company 2013
options are Silver (Ag), Copper (Cu), Silver: Copper in a 1:1 ratio (AG:CU 1-1), Silver:
Copper in a user settable ratio (Ag:Cu: M-N) or a user defined density (Define den).
When the display shows Alloy, press the [Tare] key to enter this section.
The display will show the current setting for the alloy as above.
Press the [air/Liquid] or [Density] key to change the display to another setting, then
press [Tare] to select the setting.
When the sample is gold mixed with an alloy the user needs to select the option that
describes the alloy used. If the alloy is Silver (Ag), Copper (Cu) or Silver plus Copper
in a 1:1 ratio (AG:CU 1-1) select the option shown and press [Tare] to store the
selection. The display will return to show Alloy. Press [Unit/Clr] to return to
weighing or select the Liquid setting as above.
If the alloys are in another known ratio of Silver to Copper (Ag:Cu: M-N), or the alloy
is another metal of known density (Define den) then following pressing [Tare] the
display will show the current value stored for each option. To set the ratio or density
use the [Air/Liquid] or [Density] keys to change the flashing digit, and the
[Hold/Print] key to move the flashing digit to the right. Once the value is set, press
the [Tare] key to store the value. The display will return to show Alloy. Press
[Unit/Clr] to return to weighing whereupon you are now ready to proceed as
section 5 to perform density testing.
If Platinum (Pt) has been selected for the alloy to test the balance will compute the
density based on the weight values recorded. The value for purity (karats) and
content will be computed depending on the alloy selected by the user. The alloy
options are Nickel (NI), Palladium (PA), Nickel:Palladium in a 1:1 ratio (Ni:PA 1-1),
Nickel:Palladium in a user settable ratio (Ni:PA M-N) or a user defined density (Define
den).
When the display shows Alloy, press the [Tare] key to enter this section.
The display will show the current setting for the alloy as above.
Press the [Air/Liquid] or [Density] key to change the display to another setting, then
press [Tare] to select the setting.