User's Manual

5) The following options are available for setting the serial output functions:

Mode Print Feature

Auto Mod

After density is tested it will automatically send data for

the test results to the printer as shown in section 9.

Set Mod

After density is tested and during the time the results

are displayed press [Hold/Print] to send the data to the

printer. This allows the user to print only when they are

ready. Pressing [Hold/Print] a second time will send the

data again.

Press the [Air/Liquid] key to change the setting. Press [Tare] to confirm and

move to the next setting.

6) Setting the baud rate. This is the transmission speed for communication with

printers and computers. The selected rate must match that of the other

device for communications to work.

The following settings are available:

2400 bPS

4800 bPS

9600 bPS

7) Press the [Air/Liquid] key to change the setting.

7) Press [Tare] to confirm and move to the next setting.

8) When F5 oFF is displayed press the [Tare] key to enter the parameter, the

[Unit/Clr] key to return to weighing, or press [Air/Liquid] to go to the next

function.

*Please see section 9 for more printing details