User's Manual

35 © Adam Equipment Company 2013
Format for simple weight only output:
Input command format:
The balance can be controlled with the following commands. The commands must
be sent in upper case letters, i.e. “T” not “t”.
T<cr><lf> Will do a combined Zero /Tare function the same as pressing the [Tare] key.
P<cr><lf> Will perform the same functions as pressing the [Hold/Print] key.
During a density test the P command will hold the weight, allowing the
A<cr><lf> command to be used to store the value. Will print the results at
the end of the density test.
If sent whilst displaying the density results it will cause the density report to
be printed as above.
If the Hold Function (F2 HLD) is Off the command will only print the weight
readings.
A<cr><lf> When the weight is Held on the display this command will store the weight in
memory for either weight in air or weight in liquid, the same as if the
[Air/Liquid] key is pressed.
U<cr><lf> Acts in the same way the [Unit/Clr] key does. To change the weighing unit to
the next available unit during normal weighing, or to return to normal
weighing if the balance is in the density section.
D<cr><lf> Acts in the same way the [Density] key does. When viewing results from a
density test it will change to the next displayed value.
+
1
.00 g <cr><lf>