User's Manual

36 © Adam Equipment Company 2013
10.0 REMOTE DISPLAY
The remote display plugs into the 6 pin circular connector on the rear of the
balance.
Turn the balance off.
Insert the connector from the remote display into the circular connector on the rear
of the balance.
Turn the balance on. The remote display will now display the same information as
the balance display.
NOTE: Using the remote display will use more of the battery power. It is suggested
that you should use the power supply whilst using the remote display.
11.0 TEMPERATURE SENSOR
During the density test if the balance has been set to use the auto temperature
sensor it must be plugged into the balance.
Turn the balance off.
Plug the temperature sensor into the 5 pin circular connector on the rear of the
balance.
Turn the balance back on and the sensor will now work automatically. If the sensor
becomes unplugged the display will show (0 °C au) during the power on sequence if
the automatic temperature sensor was selected in section 6.1. The balance can still
be used by setting the temperature manually as described in section 6.1. In this case
the balance after turning the power on will show the last value manually entered.