User's Manual

5 © Adam Equipment Company 2013
7) Plug the Temperature sensor into the 5 pin connector, and the remote
Indicator into the 6 pin connector at the rear of the balance.
8) Make sure again that the cable from the Temperature Sensor is tightly pulled
down through the clip and that it does not interfere or sit close to the Density
Chamber or Chamber support. If the cable is touching against any of these
parts it will result in incorrect weighing and karat calculations.
Position the balance and Remote Indicator in a convenient place and adjust the
feet to show a level state.
Switch on the balance whilst using battery power or connect the adaptor to the
mains supply.