Installation Instructions

ADAMS RITE MANUFACTURING CO.
ADAMS RITE POWER SUPPL
ADAMS RITE POWER SUPPL
Y
Y
P
P
ART NUMBER PS-LR
ART NUMBER PS-LR
260 Sant
260 Sant
a Fe S
a Fe S
treet, Pomona, CA
treet, Pomona, CA
91767•800.872.3267•Fax [phone]
91767•800.872.3267•Fax [phone]
Page 4 of 14
Rev Date: 10/2/07
80-0180-247 REV (H)
ADAMS RITE MANUFACTURING CO.
ADAMS RITE POWER SUPPL
ADAMS RITE POWER SUPPL
Y
Y
P
P
ART NUMBER PS-LR
ART NUMBER PS-LR
260 Sant
260 Sant
a Fe S
a Fe S
treet, Pomona, CA
treet, Pomona, CA
91767•800.872.3267•Fax [phone]
91767•800.872.3267•Fax [phone]
Need more information? Visit our website at:
www
www
.adamsrite.com
.adamsrite.com
1.2. STEP 2 – SET OPERATION MODE
Two operating modes are available. Set the mode with switch 1 on dip switch SW1.
Single Input – Sequential Operation (Factory Setting)
Application: Control one opening
Operation: Either input retracts Exit Device #1 immediately followed by Exit Device #2.
Dual input – Independent Operation
Application: Control two separate openings
Operation: Input IN1 retracts Exit Device #1. Input IN2 retracts EXIT DEVICE #2.
1.3. STEP 3 – SET HOLD OPEN TIMES
The Adams Rite Power Supply has two hold open timers. Set the hold open time for Exit Device #1
with switches 3, 4, and 5 on dip switch SW1. Set the hold open time for Exit Device #2 with switches
6, 7, and 8 on dip switch SW1.
The following charts show settings for a given hold time:
Solenoid Hold Time Settings for Exit Device #1
Solenoid Hold Time Settings for Exit Device #2
ROCKER
OFF
DUAL
INPUT
SINGLE
INPUT
1
2
OFF
ON
2 SEC 5 SEC 10 SEC 15 SEC 20 SEC 30 SEC 45 SEC 60 SEC
Switch 3 OFF ON OFF ON OFF ON OFF ON
Switch 4 OFF OFF ON ON OFF OFF ON ON
Switch 5 OFF OFF OFF OFF ON 0N ON ON
2 SEC 5 SEC 10 SEC 15 SEC 20 SEC 30 SEC 45 SEC 60 SEC
Switch 6 OFF ON OFF ON OFF ON OFF ON
Switch 7 OFF OFF ON ON OFF OFF ON ON
Switch 8 OFF OFF OFF OFF ON 0N ON ON