User guide

ManualsBrandsADATA ManualsComputer AccessoriesCE700

ADATA Wireless Charging Stand FAQ

CE700 Wireless Charging Stand FAQ:

1. If I just place a wireless charging cellphone on the CE700, will it automatically

start charging?

Check your phone’s manual to confirm the phone’s effective range (Rx) and

make sure that its wireless charging induction field is placed within the CE700’s

effective charging range (Tx) (Refer to circle in the figure below for optimum

charging position). Correct positioning will result in the best charging effect.

2. How to use the CE700 as a vertical charger

i. Step A: Push the slat that reads “Push” so that the upper and lower

covers separate.

ii. Step B:

With the Qi logo on the wireless charging pad upper cover facing forward,

insert the upper cover into the rubber slot with the rubber mat on the

same side as the logo

Summary of content (5 pages)

PAGE 1
ADATA Wireless Charging Stand FAQ CE700 Wireless Charging Stand FAQ: 1. If I just place a wireless charging cellphone on the CE700, will it automatically start charging? Check your phone’s manual to confirm the phone’s effective range (Rx) and make sure that its wireless charging induction field is placed within the CE700’s effective charging range (Tx) (Refer to circle in the figure below for optimum charging position). Correct positioning will result in the best charging effect. 2.
PAGE 2
ADATA Wireless Charging Stand FAQ 2 iii. b. Depending the phone’s orientation, size, and induction zone position, adjust the upper and lower covers to the most appropriate location. iv. Confirm that the metal cover plate is in flat contact with the charging cover and that the bases are level, in order to maintain the charging stand stability.
PAGE 3
ADATA Wireless Charging Stand FAQ v. vi. Connect the CE700 to the USB cable, and connect to the power supply. Place the phone's induction zone (Rx) on the induction zone (Tx) of the CE700. If the phone is larger than 5.5 inches, it is suggested to place the phone horizontally when using upright charging mode, in order to maintain alignment and stability. 3.
PAGE 4
ADATA Wireless Charging Stand FAQ aligned, and the type of power supplying the CE700. Roughly, charging time is about 1.3 times that of a wired charger. 6. Why can’t my phone be charged by the CE700? Make sure the phone is compatible with the Qi wireless charging specification, and check that the CE700 LED is on. If it is off, that means that CE700 is not receiving power. Check the power supply.
PAGE 5
ADATA Wireless Charging Stand FAQ LED A. B. C. Unlit Flashing Green Red Yellow Flashing NOTE B-1: A red light on the LED display of the CE100 indicates a red charging green failure. Make sure the charging zone (Tx) / Phone (Rx) are correctly aligned. NOTE B-2: When the LED displays a yellow light, it indicates the CE100 is in a low-power charge mode.