User’s Manual Hi-Speed USB 2.
Contents Introduction..........................................................................................................3 Features System........................................................................……….......…………...3 Requirements...................................................................................…………….……...3 Before use.........................................................................................…………………..4 Driver Installation........................................
Introduction Thank you for your purchasing this Hi-speed USB 2.0 Flash Disk. This portable Plug & Play USB Flash Disk enables you to exchange huge amount of data easily between any computers with a USB port. With high storage capacity and blazing fast speeds, this handy small device is the best choice to replace floppy disks, ZIP disks and hard disks.
Before Use 1. Please keep this Hi-speed USB 2.0 Flash Disk away from heat, direct sunlight, and water. Do not bend, flex, or drop it. 2. To prevent data loss and fatal damage to the USB 2.0 Flash Disk, please never remove it from the USB port while data is being transferred. It is advised that user perform “Safety Remove Hardware” by selecting “USB Mass Storage Device” before removing the Flash Disk. Driver Installation To use this Hi-speed USB 2.
3. It is now ready to install the driver. 4. The following window will show up when driver installation has finished. Please click Finish to exit Setup. Please re-plug again USB Flash Disk to activate the driver.
Disk Partitions and Security Function This Hi-speed USB 2.0 Flash Disk provides utility program named “USB Flash Disk Utility” to enable user to partition the Flash Disk and/or to set Security Area with password check to secure your personal data. Also, you can configure this Flash Disk as an MS-DOS Startup Disk by this utility program. Installation 1. To run the utility program, please find “USB Flash Disk Utility” in your CD, and execute it to install the utility. 2. Press Next> to install this Utility.
4. Please click Finish to exit the installation. Partition Function 1. Execute USB Flash Disk Utility Log-in/Lot-out.
2. Adjust the Slider Control Bar to you wish “security size” and “public size” 3. Click partition button then the tool will divide disk into 2 partitions. If you don’t need a security zone, you can skip this step. ※ The default password of security zone is “0000” Warrning!! Run Partition function will erase all data on the disk!! Disk Boot Function 1. Only Windows98 and WindowsME can establish Boot function. 2. Please check the Boot type you want to set. 3.
1. 2. 3. 4. 5. 6. Password Management：After you enable Partitioning, you can change manage you password here. (You can enter any number or character from 1~12 words for your password.) Old Password: Please type enter your old password. (The default password is 0000). New Password:Enter new password. Confirm Password:Confirm your new password again. Password Hint: You can enter the hint message for your new password here. Change Password: Click this to change your password.
