Switch User Manual

Managing IDSL Diagnostics
352 Avidia System Configuration and Management User Manual
The following screen illustrates an example of both line idsl commands.
Information Description
Port The slot number and port number of the IDSL card.
Up_State The current state of the IDSL Interface. Options:
• Up—The loop is up and active.
• Sync—The loop has synchronized with the first
node.
• Training—The loop is training the Digital Front End
(DFE).
• Waiting—The loop is waiting for a signal.
• Down—The loop is down or disabled.
Num_Seg The total number of segments on the loop.
Node ID The node tested. The values are 0 (Avidia system) up
to 7.
Diag Code The type of diagnostic enabled.
• Loopback—Loopbacks are enabled on this port.
• CrcTest—The Corrupted CRC test is enabled on
this port.
::idsl=> line 5.1
Node Diag
Port Up_State Num_Seg Id Code
5.1 down 0 0 Loopback
::idsl=> line
Node Diag
Port Up_State Num_Seg Id Code
5.1 down 4 3 Loopback
5.2 up 0 0 CrcTest
5.3 down 0 0 Loopback CrcTest
5.4 waiting 5 1 CrcTest
5.5 down 0 0
5.6 down 0 0
5.7 down 0 0
5.8 down 0 0
5.9 down 0 0
5.10 down 0 0
5.11 down 0 0
5.12 down 0 0
5.13 down 0 0
5.14 down 0 0