Datasheet
Technical data APCI-3xxx
4.3.1 Analog inputs
Number of channels: .................................. 16 analog inputs
Resolution (APCI-3010 and APCI-3110): 12-bit
Resolution (APCI-3016 and APCI-3116): 16-bit
Max. throughput rate: ................................ 200 kHz (total sampling rate
with all channels)
Optical isolation: ........................................1000 V (1 second tested)
Temperature drift: ......................................10 ppm/K
Linearity error of the ADC:........................±1.22 mV (typ.)
±2.44 mV (max.)
Calibration of the inputs:
Bipolar offset calibration value:.................-0.00061 V (tolerance: ±0.0017 V)
Unipolar offset calibration value:...............0.01 V (tolerance: ±0.0017 V)
Bipolar gain calibration value:...................9.995 V (tolerance: ±0.0017 V)
Unipolar gain calibration value:.................9.995 V (tolerance: ±0.0017 V)
Calibration channel: ...................................0 (single-ended)
Measurement method:................................Averaging of more than 200 values
4.3.2 Analog outputs
Analog outputs are available on the following boards:
- APCI-3110
- APCI-3116
Number of channels: ................................. 4 analog outputs
Output type:................................................ Voltage outputs: Single-ended
Resolution: ................................................ 12-bit
Output range: ............................................. - 10 V to (+ 10 V – 1 LSB)
LSB: .......................................................... 4.8828 mV
Precision: ................................................... 11-bit
Time to ready (tr): .................................... 5 μs
Settling time
(=tr + settling time des DACs): ................. typ. 15 µs (at 10 V interval)
Temperature drift: ..................................... max. 10 ppm/°C
Max. output current: .................................. ± 5 mA
Short circuit current: ................................. ± 20 mA
Optical isolation: ........................................1000 V (1 second tested)
Voltage after reset: .................................... 0 V (see also chapter 8.3)
4.3.3 Digital inputs (24 V
Number of channels: ..................................4 digital inputs
Filter/protective circuit:..............................Low pass/transorbdidodes
Optical isolation: ........................................1000 V
Nominal voltage:........................................24 V
Input voltage: .............................................0 V to 30 V
Input current:..............................................10.5 mA (at 24 VDC, typ.)
14