User`s guide

Controller Installation
Adept SmartController User’s Guide, Rev. K 25
Removing CompactFlash
To remove a CompactFlash (CF) from a SmartController:
1. Make sure that the SmartController is disconnected from its power source.
2. Locate the CF compartment (see the following figure).
Figure 2-5. CompactFlash Memory Card Compartment
NOTE: If you are replacing an existing CF, the original must be sent to
Adept for replacement.
3. Press the button inside the CF compartment to eject the card.
Remove the card and return it to Adept. Contact Adept Customer Service.
Installing CompactFlash
To install a CompactFlash (CF) into a SmartController:
1. Make sure that the SmartController is disconnected from its power source.
2. Locate the CF compartment (see Figure 2-5).
3. Carefully remove the CF from the READ ME FIRST box or shipping container.
Locate the CF slot and position the card so its contacts are facing towards the
SmartController and the label is facing up.
4. Insert the CF into the SmartController.
Once installed, Adept recommends that you do not repeatedly remove and insert the CF.
CAUTION: Do not remove the CompactFlash when power
is connected to the SmartController.
CompactFlash
Compartment
Eject Button