User`s guide

Chapter 4 - SmartController Maintenance
60 Adept SmartController User’s Guide, Rev. K
7. The lamp body is now free. You can remove the old lamp and insert a new one.
8. Replace the lamp body by pushing it straight into the lamp housing receptacle.
Make sure the contacts on the lamp body are properly oriented. See Figure 4-1 on
page 60.
9. Make sure to reconnect the wires from the LED if you disconnected them earlier.
Push the front cover into the body, taking care to align all of the plug-type
connectors. Verify that the wires do not get crimped as you reinstall the cover.
10. Replace the two screws on the back of the body.
11. Reinstall the Front Panel in its mounting.
12. Reconnect the cable between the Front Panel and the SmartController.
Figure 4-1. Lamp Body Contact Alignment
High Power On/Off
Lamp Body
Back side of front cover
Wires between LED and
body of Front Panel.
Be careful when separating
front cover from body to avoid
damaging the wires.