User`s guide

Configuring an sDIO
Adept SmartController User’s Guide, Rev. K 71
sDIO Inputs/Outputs
Up to four sDIO modules can be added to a system. The first sDIO occupies the first 4
bytes of block 16. See Figure A-8 on page 72. Additional sDIO modules need to be
configured using the controller object editor in Adept ACE.
Refer to the steps under “Configuration Procedure” on page 69, and the values in Figure
A-8.
After selecting block numbers, you must assign groups of signal numbers to each block.
NOTE: You must select a unique block number for the Inputs and
Outputs of each sDIO in your system. Repeat the procedure above for
each sDIO.
Assigning I/O Signal Numbers
The I/O signal number ranges are valid for the sDIO:
• Inputs 1033 to 1512
• Outputs 0033 to 0512