Operation Manual

4. Press D to stop chronograph; press and hold D to reset to zero when the

chronograph is stopped.

5. Press and hold A to save data to MY LOG.

MY LOG MODE

1. Press B to change to my log mode.

2. Press E to view data within the selected SET.

3. Press and hold E to race against any SET. This will put you in SHADOW RACE mode.

4. Press D to advance through saved sets.

5. Press and hold D to clear selected set. Continue holding to clear all sets.

NOTE: You can save up to 100 total laps in the memory.

SHADOW RACING

This function allows you to easily race against yourself from a previously stored

session of data that can be found under “MY LOG.” Take a lap reading at the marker

and the watch will tell you how you compare to your previous race.

1. Press B to change to MY LOG mode.

2. Press D to select set of data to race against.

3. Press and hold E to enter shadow racing chronograph.

4. Press C to start shadow race mode.

5. Press and hold A to save run data when the chronograph is stopped.

NOTE: Shadow race mode will beep 5 seconds before reaching previous stored lap time.

ALARM MODE

1. Press B to change to alarm mode.

2. Press D to toggle between alarms 1 and 2.

3. Press E to toggle alarm on/off.

4. Press and hold A to set the alarm.

5. Press E to increase setting value. Press D to decrease setting value.

6. Press B to set and advance to next setting value.

7. Setting sequence is hour, minute, T1-T2.

8. Press A to save data and exit setting mode.

NOTE: Alarm status will be ON automatically after exit the ALARM SETTING mode. No

button operation for 60 seconds will auto-exit with changes saved, but alarm status OFF.