Specifications

ADJ Products, LLC - www.adj.com - Crazy 8 User Manual Page 12 ADJ Products, LLC - www.adj.com - Crazy 8 User Manual Page 13
Show Mode - Show modes 1 - 4 (Factory Shows).
1. Press the MENU button until “Show Mode” is displayed, press
ENTER.
2. “Show X” will now be displayed, “X” representing a number between
1-4. Press the UP or DOWN buttons to nd your desired show and
press ENTER to conrm. After pressing ENTER, press and hold the
MENU button for at least 3 seconds to activate.
Dimmer Mode - In this mode you can select the dimmer
curve. See page 26 for the different dimmer modes.
1. Press the MENU button until “Dimmer Mode” is displayed,
press ENTER.
2. The current dimmer mode will be displayed.
3. Press the UP or DOWN buttons to nd your desired dimmer
mode and press ENTER to conrm.
Sound Mode - In this mode the unit will run in sound
active mode.
1. Press the MENU button until “Sound Mode” is displayed, press
ENTER.
2. Either “On” or “O” will now be displayed. Use the UP or DOWN
buttons to toggle between “On” and “O”.
3. Press ENTER to conrm your selection, the press and hold the
MENU button to activate.
Black Out - This mode can be used as a precaution mode,
that in case the DMX signal is lost, interrupted, or power is
lost, the operating mode chosen in the setup is the running
mode the xture will go into when the DMX signal is lost. You
can also set this as the operating mode you would like the
unit to return to when power is applied.
Crazy 8 System Menu
1. Press the MENU button until “Black Out” is displayed, and either
“Show”, “Blackout”, or “Hold” will be displayed beneath.
2. Press ENTER and the bottom choice will begin to ash. Use the UP
or DOWN buttons to choose an operating mode you would like the unit
to start up in when power is applied or the DMX signal is lost.
• Show - If the DMX signal is lost, or interrupted, the unit will automati-
cally go into the last selected show mode.
• Blackout- If the DMX signal is lost or interrupted, the unit will auto-
matically go into stand by mode.
• Hold - If the DMX signal is lost, or interrupted, the xture will stay in
the last DMX setting. If power is applied and this mode is set, the unit
will automatically go into the last DMX set up.
3. Press ENTER to conrm your desired set up.
Back Light - With this function you can make the back-
light automatically turn off after one minute.
1. Press the MENU button until “Back Light” is displayed, press ENTER.
2. Either “On” or “O” will now be displayed. Press the UP or DOWN
buttons to select “On” to keep the backlight on at all times, or “O” to
allow the backlight to turn o after 2 minutes. Press any button to turn
the backlight on again.
3. Press ENTER to conrm.
Pan Invert - Pan Inversion
1. Press the MENU button until “Pan Invert” is displayed, press
ENTER. Either “Yes” or “No” will be displayed.
2. To activate the Pan inversion press the UP or DOWN buttons until
“Yes” is displayed, press ENTER to conm. To deactivate Pan inver-
sion, select “No” and press Enter.
Tilt Invert 1 - Tilt Inversion
1. Press the MENU button until “Tilt Invert 1” is displayed, press
Crazy 8 System Menu