User`s guide

Installation • 9
2.4 Jumper Descriptions
The only one jumper (JP1) on the PCI-9111 card is used to set the range
of the analog output channel. The analog output range could be unipolar
(0~10V) or bi-polar (-10V~+10V). The default setting is bi-polar.
Analog output range is
-10V~+10V
Analog output range is
0V~ + 10V
UI
BI
JP1
UI
BI
JP1
Figure 2.2 Analog output range setting
2.5 Hardware Installation Outline
Hardware configuration
The PCI cards (or CompactPCI cards) are equipped with plug and play
PCI controller, it can requests base addresses and interrupt according to
PCI standard. The system BIOS will install the system resource based on
the PCI cards’ configuration registers and system parameters (which are
set by system BIOS). Interrupt assignment and memory usage (I/O port
locations) of the PCI cards can be assigned by system BIOS only. This
system resource assignment is done on a board-by-board basis. It is not
suggested to assign the system resource by any other methods.
PCI slot selection
The PCI card can be inserted to any PCI slot without any configuration for
system resource.
Installation Procedures
1. Turn off your computer.
2. Turn off all accessories (printer, modem, monitor, etc.) connected to
your computer.
3. Remove the cover from your computer.
4. Setup jumpers on the PCI or CompactPCI card.