Owner's Manual

INSTALLATION
1. Do not use for a minimum of 24 hours before installing if the unit has been transported.
2. Ensure unit is at the appropriate temperature prior loading it with product.
3. Make sure that the unit has proper ventilation in its location.
4. Review manual in its entirety. Misuse of this unit will void the warranty.
LOCATION
1. Install the unit on a flat sturdy surface to avoid unit malfunction
2. Install the unit in an indoor, well ventilated area
3. Maintain a clearance of at least 6” from all sides of the unit
4. Do not install in a high humidity or dusty area as this will cause the unit to
malfunction
5. Select a location away from heat and moisture generating equipment as
malfunction due to high ambient temperature will void warranty
ELECTRICAL
Ensure that the required voltage of the compressor is constant all of the time. Voltages that are
either too low or too high will cause the unit to malfunction thereby voiding the warranty.
Unit must be plugged into a properly sized grounded electrical outlet with over-current
protection. Make sure that the unit has its own dedicated outlet. Do not use an extension cord.
TEMPERATURE CONTROLS
This unit’s temperature control is factory set to an average temperature of 38 F. To change the
temperature, adjust the control inside the unit. To decrease the temperature and make the
temperature cooler, turn the knob clockwise. To increase the temperature and make the unit
warmer, turn the knob counter-clockwise.
LOADING PRODUCT
DO NOT LOAD PRODUCT ABOVE THE TOP CROSS BAR OF THE BIN DIVIDERS OR
ABOVE THE LOAD LIMIT STICKERS. LOADING PRODUCT ABOVE THE LOAD LIMIT
STICKERS WILL HARM THE PERFORMANCE OF THE UNIT AND WILL VOID THE
WARRANTY.