Installation Guide

Fig. 2
If the project requires corners, install
the corner first and work out on both
sides. Corners should be installed with
each course. Each corner piece needs
two screws or nails to securely attach.
Inside corners use the same corner
pieces reversed.
During the installation, some panels will need to be cut to fit and the attaching flange will need to be
removed. To remove the flange, carefully cut off with snips. This may produce sharp edges so handle with
care. Pieces without the attaching flange will need to be installed with adhesive. In order to achieve a good
bond, a non-painted, clean flashing material must be attached to the structure first. After the bonding
surface has been installed, use a heavy duty construction adhesive such as PL Premium to install the Adorn
pieces. Additional temporary support may be needed until adhesive cures.
Window
To install a sill under a window, carefully remove
the attaching flange and glue with a heavy duty
construction adhesive. Place adhesive to the
back and the bottom of the sill piece being
installed.
Our product is designed to allow natural
movement that protects from freezing, thawing,
and settling. If you use adhesive on the Adorn
panels, only place in the noted area to allow for
drainage.