Installation Guide

Attach the base course:
Place 4 Pillar Stones
around the base as shown.
Level the base course and
attached with 2 screws per
Pillar Stone through the
flashing approximately 1”
above the stone veneer.
Continue installing the
Pillar Stones one course at
a time. Square up the
corners, check for level
and attach with screws.
Adorn Pillar Stone Installation
Natural Concrete Products – www.naturalconcreteproducts.com
Construct the pillar base
using 2” X 2”’s and OSB or
plywood to the desired
height. Each Pillar Stone is 6”
high so designing the height
in 6” increments will
eliminate cutting of the Pillar
Stones. The outside
dimensions need to be 14” X
14”. Cover the frame with an
ice and water resistant type
of wrap. It is recommended
to use treated lumber
(2”X4”)on the base. Anchor
the pillar as needed.
When you get to the top
course, bend the flashing over
the frame and screw in place.
Place a bead of construction
adhesive around the top of the
Pillar Stones. Set the Pillar Cap
in place.
The finished pillar will be
approximately 18” square.
Tools needed to install
Safety glasses, gloves, measuring tape, caulking gun, level, stainless steel screws and construction
adhesive. Safety first is the number one priority with any construction project. Always wear safety
glasses and gloves when handling Adorn Pillar Stone.