Installation Guide

For applications where the Adorn system will
terminate without a corner return, one suggestion is to
have the Adorn veneer extend past the structure the
width of the siding, corner trim, J channel, etc, on the
return. For a finished look, place the panels with the
factory edge exposed. The sills are installed the same
as the panels with a minimum of 3 fasteners with 1 of
these into a stud to a depth of 1”.
To finish projects where Adorn is to be installed up to
the soffit, measure the distance from the last full panel
installed to the soffit. Cut Adorn panels to fit and glue
into place using construction adhesive, such as PL
Premium or Dap DynaGrip. You may need to trim the
attaching flange from the last full panel or securely
attach a nonpainted, clean flashing material to the
structure to achieve a good bond surface.
Important information:
Ensure that Adorn is being installed to a structure that meets all building code requirements. Code approved
flashing must be used at all terminations, penetrations, and material transitions. Control moisture penetration
caused by run off, gutters, and downspouts. If there is any question as to the integrity of the structure, contact
the appropriate professional to correct. Adorn should maintain a 2” clearance from hard surfaces such as pave
When cutting, grinding, or trimming any Adorn pieces, always follow the tool manufacturer’s safety instructions
and use the appropriate safety protection.
Cutting dust and general construction dust can be removed with clean water and if needed, a nylon bristle brush.
Do not clean with a power washer, harsh chemicals, or acid products.
The small side of the corner occasionally may not fit as snug as desired. If needed, a dab of construction adhesive
can be applied to the back of the piece to ensure a snug fit.
The corners are manually checked to fit together and are packaged as a set. There are 4 sets placed in the box
together and the remaining 2 sets have the 5.5” pieces at one end of the box with the 2 9.5” pieces lying flat on
the top. When installing corners, use the sets as they are shipped.
Adorn / Rust-Oleum coordinating colors to touch up the base color:
Colorado Gray - #249279 Primer Gray Desert Tan - #7772 Putty
Northern Gray - #249279 Primer Gray Terra - #249857 Satin London Gray
Buckskin - #7226 Bronze