Installation Guide

Adorn Post Stone Installation
Natural Concrete Products – www.naturalconcreteproducts.com
Natural Concrete Products (NCP) warrants Adorn for 30 years to the original consumer purchaser. This warranty
covers manufacturing defects and covers the replacement cost of materials only, labor is not included. This
warranty does not cover improper application, minor chipping, or minor cracks that do not affect the proper
placement or impair the strength of the product. Adorn products are not warranted against discoloration due to
normal weathering, air pollution, or chemicals. NCP is not responsible for the corrosion resistance of fasteners.
Adorn Post Stone is designed to fit on a 6” X 6” post.
When using treated wood, a layer of a peel & stick rubberized asphalt membrane must be used, like
ProtectoWrap Deck Joist tape, or equivalent. The fastener used must be rated to be used on treated
wood, GRK R4, U2 Universal, or equivalent.
Tools needed to install:
Safety glasses, gloves, measuring tape, caulking gun, level, proper screws and construction adhesive.
Safety first is the number one priority with any construction project. Always wear safety glasses and
gloves when handling Adorn Post Stone.
Attach the base course:
Place 4 Post Stones around
the base of the 6” X 6” post
as shown. Level the base
course and attach with 2
screws per Post Stone
through the attaching
flange approximately 1”
above the stone veneer.
Continue installing the Post
Stones one course at a
time. Square up the
corners, check for level,
and attach with screws.
Place a small dab of
adhesive on the back of
each stone approximately
1” from the bottom and
adhere to the attaching
flange of the piece below.