Owner's manual

ADS Eureka Digital System User Manual

Restore Defaults

Selecting this button restores the program defaults where changes have

been made.

Transducer Positions

This section of the Pipe tab is for setting the transmitter information.

Use each drop-down menu to select the appropriate transmitter color, from

left to right, in the pipe network. A grey selection indicates no transmitter.

Consider using the yellow option when using the Receiver Unit as an input

with a plug-in transducer. Once selections are completed, click on the

Apply button to set the changes.

Yellow Transducer

When using three transducers, enter the distance from the middle

transducer to the left transducer. Adding a 3

transducer changes the

correlation display so that tabs at the top allow selections between the

different combinations of transducers.

Hydrophones

Select this checkbox when using hydrophones.

Calculate

Use Calculate to determine the velocity of sound in the pipe in either 2-

Transducer mode or 3-Transducer mode.

Velocity Calculation (2-Transducer Mode)

This allows measurement of the actual velocity of sounds in the pipe(s).

However, a leak in the pipe must exist at a known position, typically

produced by opening a hydrant. Two primary options are available for the

leak position: Out-of-Bracket or Between Sensors.