Manual

Configuration and Activation 6-61
 DMI Port (This parameter does not apply to the
FlowHawk)
 Timeout Enter the number of seconds you want your
local computer to wait for a response from the monitor
once communication has been initiated.
 Attempts Enter the number of times you want your local
PC to request data from the monitor following a failed
attempt while the monitor is still on line.
 Low Temperature Enter the temperature reading from
the monitor, ultrasonic upward depth sensor, and pressure
depth sensor below which you want Profile to provide
notification.
 High Temperature Enter the temperature reading from
the monitor, ultrasonic upward depth sensor, and pressure
depth sensor above which you want Profile to provide
notification.
 Log Communications Select this checkbox to record
all communication activities with the monitor.
 Status on Connect Select this checkbox to view details
of the current state of the monitor when monitor
communications are established. If you do not want to
view the monitor status details at connect, do not select this
checkbox.
 Low Battery 1502, 1506, 3500, 4000 (These
parameters do not apply to the FlowHawk)
 Low Modem Battery TCP/IP (This parameter does not
apply to the FlowHawk)
 Low Signal Strength TCP/IP Enter the signal strength
(in dBm) below which you want Profile to provide
notification for the wire communication unit, when
applicable. IETG recommends using -95 dBm for the low
signal strength.
 Low Battery FlowShark (This parameter does not
apply to the FlowHawk)