User manual

Chapter 3. Configuration
61185001L1-1 MX2810 M13 User Manual 3-35
3. Select L
OAD AND
U
SE
C
ONFIG
.
Resetting the System
The system must be manually reset after downloading new
software. When the unit has successfully loaded and programmed
the new software into its FLASH memory, it will begin uploading
the code to the stand-by controller. This will be indicated on the
menu and the
ACT LED
on the stand-by card will display solid
yellow.
Once the upload is complete, the stand-by card will self-reset and
begin running the new code. However, the active card does not
reset automatically. The unit must be reset through the I
MMEDIATE
R
ESET
or S
CHEDULE
R
ESET
T
IME
functions.
SAVE CONFIGURATION AND ALARM LOG
Commits the current configuration and alarm log to nonvolatile
memory. If this option is not selected after making changes to the
configuration, the unit reverts to its previous configuration when
powered down.
Configuration changes will not be implemented until all Telnet
sessions are closed. Loading a new configuration may disrupt data
traffic.
The stand-by card must remain in place until the process is
complete and the
ACT LED
is no longer solid yellow. Removing
the stand-by card during the uploading process will corrupt the
software.