Specifications

61200600L1-1A © 2002 ADTRAN, Inc. 137
Total Access 600R System Manual Section 5 DLP-003
The unit contains six different password levels. The table below gives a brief description of each level.
Follow-up Procedures
Once this procedure is complete, return to the procedure which referred you to this DLP and continue with
the tasks indicated there.
Security Level Description
Full The user has all access to view and configure all menus (same as logging in to
the CRAFT port).
Support The user has access to view S
YSTEM INFO. The user has privileges to view and
change everything under the S
YSTEM CONFIG menu except for the CRAFT port
settings, T
ELNET ACCESS lists, and the SNMP MANAGEMENT COMMUNITIES. The
user has full access to the S
YSTEM UTILITY menu, including the ability to upgrade
firmware and reset the unit. The user has full access to the I
NTERFACES, L2
P
ROTOCOL, BRIDGE, ROUTER, and DS0 menus. The user does not have the
ability to set R
ADIUS SERVER settings under the SECURITY menu.
Config The same privileges as support, except that the user does not have privileges to
download firmware or configuration from the S
YSTEM UTILITY menu. The user
additionally does not have the privilege to reset the unit remotely or enter the
terminal menu.
Router The user has view-only privileges of S
YSTEM INFO. There is no access to the
S
YSTEM CONFIG menu. The user has PING and TRACEROUTE access from the
S
YSTEM UTILITY menu. The user is limited to Ethernet configuration and status
from the I
NTERFACES menu. The user has full access to the BRIDGE and ROUTER
menus. Access is limited to filters only from the S
ECURITY menu.
Status The user has read access of all menus except for the following: S
YSTEM CONFIG/
CRAFT P
ORT, SYSTEM CONFIG/TELNET ACCESS, SYSTEM CONFIG/SNMP
M
ANAGEMENT, and SECURITY/ RADIUS SERVER. The user does not have access
to U
PGRADE FIRMWARE, UPGRADE CONFIG, PING, or TRACEROUTE menus. The
user cannot reset the unit or enter terminal mode.
In the A.03 firmware, only one Telnet session can be active at a time. The A.04 firmware
will support five simultaneous Telnet sessions.
In the A.03 firmware, the default conditions for the username and password fields are to
have no entries in these fields.
In the A.04 firmware, the default username and password are guest and password,
respectively.