Specifications

Total Access 600R System Manual Section 4 User Interface Guide

SYSTEM CONFIG > MANAGEMENT > SNMP MANAGEMENT > TRAPS

Sets up the trap manager name and IP from this menu.

SYSTEM CONFIG > MANAGEMENT > FDL MANAGEMENT

Enables the FDL management and configures mode and IP addresses from this menu.

SYSTEM CONFIG > MANAGEMENT > FDL MANAGEMENT > MODE

This enables the FDL (only in ESF mode) to be used for management. Learning mode can also be enabled

so the unit can "learn" its IP configuration to be used for its FDL management. Once it learns this

information from, for example a Total Access 4303, the configuration items populate. The factory default

ON.

SYSTEM CONFIG > MANAGEMENT > FDL MANAGEMENT > LINK IP ADDRESS

This is the local IP address used for FDL management. The FDL uses a separate IP network for

communication, distinct from the customer data that is configured under the

ROUTER menus. The factory

default is

0.0.0.0.

SYSTEM CONFIG > MANAGEMENT > FDL MANAGEMENT > IP NETMASK

This is the subnet mask defining the IP network used for FDL management. The factory default is 0.0.0.0.

SYSTEM CONFIG > MANAGEMENT > FDL MANAGEMENT > FAR-END IP ADDRESS

This is the far-end IP address used for the FDL management. The FDL is a separate IP network from the

customer data that is configured under the

ROUTER menus. The factory default is 0.0.0.0.

SYSTEM CONFIG > MANAGEMENT > FDL MANAGEMENT > LEARN ADDRESS

When set to ON, the destination address on each received packet is assumed to be the FDL interface

address. A 255.255.255.252 netmask is used, which determines the far-side address as well (since there can

be only two addresses on a subnet with that netmask). When set to

OFF, the user must input the IP address

assigned to the FDL interface. Default is

ON.

Displays the index number in the SNMP traps table.

This list allows up to 20 managers to be listed to receive traps.

MANAGER NAME is the text string describing the name of the entry. It is intended for easy reference

and has no bearing on the SNMP trap function. You can enter up to 31 characters in this field. The

factory default is no entry in the manager name field.

MANAGER IP

This is the IP address of the manager that is to receive the traps. The factory default is 0.0.0.0.