Specifications

Total Access 600R System Manual Section 4 User Interface Guide

entry that has 0 in the DLCI field. This entry is considered the default entry to use when no match occurs.

If this default entry is not present, the unit falls back to using IARP to determine the protocols to use with

that particular virtual circuit. If a static maintenance protocol is used, at least one DLCI mapping must be

specified.

L2 PROTOCOL (T1[0] - FRE) > CONFIG > DLCI MAPPING > NUM

Displays the index number in the DLCI mapping table.

L2 PROTOCOL (T1[0] - FRE) > CONFIG > DLCI MAPPING > ACTIVE

When this parameter is set to YES (def), the mapping is used to determine the protocols used. If set to NO,

the unit will ignore the virtual circuit with this DLCI.

L2 PROTOCOL (T1[0] - FRE) > CONFIG > DLCI MAPPING > INTERFACE

Shows the user the physical and logical port associated with each DLCI. This is a read-only field.

L2 PROTOCOL (T1[0] - FRE) > CONFIG > DLCI MAPPING > DLCI

The DLCI number identifies the virtual circuit being configured.

L2 PROTOCOL (T1[0] - FRE) > CONFIG > DLCI MAPPING > MODE

The mode identifies how the data will be forwarded. The choices are;

The default is

ROUTE IP.

L2 PROTOCOL (T1[0] - FRE) > CONFIG > BECN TIMEOUT (MSEC)

This value is expressed in milliseconds and represents the amount of time the unit will stop transmitting

over a PVC which received a packet with the BECN bit set. Range is

50-5000 msec; the default is 50 msec.

To insert a new profile, press the I key when over the Num column. A new inserted profile

will always be set up with the default parameters. To copy parameters from an old profile

to this newly inserted profile, use the copy (C) and paste (P) keys. Entire configuration

trees can be copied with this method.

To delete an unused profile, use the D key when the cursor is over the number in the Num

column. Once deleted, the profile is gone permanently.

ROUTE IP

All IP data for this DLCI will be routed

BRIDGE ALL

All data for this DLCI will be bridged

ROUTE IP/BRIDGE OTHER

All IP data will be routed. All other data will be bridged.