User manual

61200236L1-1 NT1 ACE
3
User Manual 7
NT1 ACE
3
User Manual
Powering with the NT1 ACE
3
Power Supply
The ADTRAN NT1 ACE
3
Power Supply, part number
336012VUR01, provides power to the NT1 ACE
3
. To connect
the NT1 ACE
3
to the external power supply, perform the fol-
lowing steps as illustrated in Figure 1-5.
1. Connect the Power Supply to the NT1 ACE
3
at the
POWER jack located on the NT1 ACE
3
rear panel.
2. Plug the Power Supply into the nearest wall outlet
supplying 120 VAC, 60 HZ.
3. On the NT1 ACE
3
, verify that the ERROR indica-
tors are illuminated. After approximately 15 sec-
onds, the READY indicators should flash at a 1 Hz
rate. Should any of the indicators fail to operate as
stated, see the section Troubleshooting on page 10 .
Figure 1-5
Power Supply Connection
NT1 ACE
3
3
READY
ERROR
1
READY
ERROR
2
READY
ERROR
100 - 120
VAC
NETWORK
POWER
LOCAL