User's Manual

ManualsBrandsAdvance Security ManualsAutomotiveCar Alarm Receiver

JULY. 19. 2002

560A

OPERATION:

A. REGULAR TRANSMITTER OPERATION:

Transmitter Button System Function Remark

Lock Doors & Arm System with Chirp Press & release within 1 seconds

Lock Doors & Arm System without Chirp Press & release over 1 seconds

Arm and Delete The 2 Stage Shock Sensor Press twice within 3 seconds.

(3-second)

Panic function Press and Hold for 3 seconds

Unlock Doors & Disarm System with Chirp Press & release within 1 seconds

Unlock Doors & Disarm System without Chirp Press & release over 1 seconds

Two Steps Door Unlock & Disarm System Press twice within 3 seconds.

(2-second)

Channel 2 (Trunk) Timer Control Press and Hold for 2 seconds

Activate or Turn Off The Remote Start or Press twice within 3 seconds.

B. LED display:

LED Function LED Function

Off Disarmed Zone 1: Warn-Away Trigger

Slow Flash Armed 2 flashes... pause Zone 2: Trigger on Trunk/Hood

Fast Flash Passive Arming 3 flashes... pause Zone 3: Trigger on Door Switch

On (Solid) Valet Mode 4 flashes... pause Zone 4: Trigger on Optional Sensor

5 flashes... pause Zone 5: Trigger on Ignition Switch

C. CHIRP INDICATORS: D. PARKING LIGHT:

Chirp Function Parking light Function

1 chirp Arm 1 flash Arm

2 chirps Disarm 2 flashes Disarm

3 chirps Defective Reminder 3 flashes Disarm / Triggered

4 chirps Disarm / Triggered 12 flashes Car Locator

Constant On Under Remote Start

E. ALARM OPERATING CONDITION:

Siren, Horn Parking Light LED Doors Starter Dome Light

1. Arming 1 or 3 Chirps 1 Flash Slow Flash Locking Disable

2. Disarming 2 or 4 Chirps 2 or 3 Flashes Fast Flash Unlocking Turns on for 30-second

3. Trigger Alarming Flashes Slow Flash Disable Flashes

4. Panic Alarming Flashes Flashes

F. ACTIVE LOCK & ARM:

1.Press button on the transmitter.

2.The horn will chirp once and parking light will flash once indicating that the system is now armed. The vehicle

doors will lock upon arming when interfaced with the security system.

SILENT ARMING / DISARMING: Press and hold the

button on the transmitter over 1 second will arm

or disarm your security system, No chirp sound will be heard, arm / disarm confirmation will be through the

vehicles parking lights only.

DEFECTIVE SENSOR REMINDER: If the siren sounds 3 chirps, then you have left a door, trunk, or hood lid ajar.

(See Alarm Feature “I

4 Programming)

SHOCK SENSOR / OPTIONAL SENSOR BY-PASS:

Press the

button once: The siren chirps once, The system is armed.

Summary of content (5 pages)

PAGE 1
JULY. 19. 2002 OPERATION: A. REGULAR TRANSMITTER OPERATION: Transmitter Button (3-second) (2-second) - System Function Lock Doors & Arm System with Chirp Remark Press & release within 1 seconds Lock Doors & Arm System without Chirp Arm and Delete The 2 Stage Shock Sensor Press & release over 1 seconds Press twice within 3 seconds.
PAGE 2
JULY. 19. 2002 Press the button a second time within 3 seconds: The siren chirps twice, the Shock Sensor is now bypassed. The sensor bypass feature is programmed to activate for one arming cycle only. The security system will return to normal operation during the next arming cycle. H. PASSIVE ARMING Active arming / disarming is controlling your security system via the remote transmitter.
PAGE 3
JULY. 19. 2002 1. Press and hold the button for 3 second. The alarm will immediately sound. 2. During panic mode, the normal function of this transmitter button will be suspended. The and buttons can be used to lock and unlock the doors (if the option is installed), however once the button is pressed, the vehicle’s starter disable device, (where installed) will be enable allowing the vehicle to start. 3. To stop the alarm, press and hold the or button on the transmitter again for 3 seconds.
PAGE 4
JULY. 19. 2002 2. The parking light will activate to indicate the remote start received the signal. 3. The engine will start approximately 5 seconds. 4. Once the engine is running, after couple seconds the parking light will turn on again and climate controls will activate and adjust the vehicles interior temperature to your preset setting. 5. The vehicle will run for 5 to 30 minute cycle and automatically shut down.
PAGE 5
JULY. 19. 2002 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. CAUTION: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user’s authority to operate the equipment.