User's Manual

ManualsBrandsAdvance Security ManualsAutomotiveCar Alarm Receiver

JULY. 19. 2002

560A

Press the

button a second time within 3 seconds: The siren chirps twice, the Shock Sensor is now

bypassed.

The sensor bypass feature is programmed to activate for one arming cycle only. The security system will return

to normal operation during the next arming cycle.

H. PASSIVE ARMING

Active arming / disarming is controlling your security system via the remote transmitter. This security system is

equipped with an optional Passive Arming feature, which allows the security system to arm 30 seconds after the

last door is closed. Operation is as follows.

1. Turn the ignition to the “OFF” position and exit the vehicle.

2. After all entrances are closed, the security system LED will flash fast for 30 seconds. If you reopen any door

/ hood / trunk, the security system LED will stop flashing. It will begin flashing again once the vehicle all

entrances are closed.

3. After 30-second timer has elapsed, the sec urity system will automatically “ARM”. The siren will chirp [1] time

and the parking lights will flash [1] time.

PASSIVE ARMING WITH PASSIVE DOOR LOCKING (See Alarm Feature “I

2” Programming):

The vehicle doors will automatically lock after passive arming cycle has been completed.

G. ACTIVE UNLOCK & DISARM:

1. Press button on the transmitter.

2. The horn will chirp twice and parking light will flash twice to indicating that the security system is now

disarmed. The vehicle doors will unlock and dome light wills turns on for 30 seconds upon disarming when

interfaced with the security system.

TAMPER DISARMING: If alarm triggered, upon disarm the system, siren chirp 4 times, parking light flash 3

times.

PATHWAY ILLUMINATION (See Alarm Feature “II

4” Programming): This feature turns the parking light

“ON” for 30 seconds upon a unlock signal and for 10 seconds upon the lock signal.

TWO STEPS DOOR UNLOCK (See Alarm Feature “III - 3” Programming):: This feature will independently

unlock the drives door only when disarming the security system. Pushing the button a second time within

3 seconds will unlock the entire vehicle.

H. DISARMING WITHOUT A TRANSMITTER

The Override function may be used if the remote transmitter is lost or inoperative.

1. Enter the vehicle and turn the ignition switch to 'ON’ position.

2. Within 10 seconds push and release the valet switch

The alarm will enter the disarm mode. You can now start and operate the vehicle normally.

I. VALET MODE: (System in Disarm or Valet mode)

The valet switch allows you to temporarily bypass all alarm function, eliminating the need to hand your

transmitter to parking attendants or garage mechanics. When the system is in valet mode, all alarm function

and remote start function are bypassed, however the remote panic feature and remote door locks will remain

operational. To use the valet mode, the system must first be disarmed either by using you remote transmitter,

or by operating the Manual override sequence.

Enter Valet Mode:

1.From the disarmed condition, turn the ignition to “ON” position.

2.Push and hold valet switch for 2 seconds until the LED turns on. The LED wills remain on as long as the

system is in 'valet mode'.

Exit Valet Mode:

1.Return to normal operation, turn ignition 'on'.

2.Push and hold valet switch for 2 seconds, The LED wills turns off indicate the system are exiting the valet

mode.

J. PANIC FUNCTION:

The transmitter can be used as a remote panic switch to manually trigger the alarm in case emergency.