User's Manual

JULY. 19. 2002
560A
3
1. Press and hold the button for 3 second. The alarm will immediately sound.
2. During panic mode, the normal function of this transmitter button will be suspended. The and buttons
can be used to lock and unlock the doors (if the option is installed), however once the button is pressed,
the vehicle’s starter disable device, (where installed) will be enable allowing the vehicle to start.
3. To stop the alarm, press and hold the or button on the transmitter again for 3 seconds. Also if any
transmitter button other than the or button is pressed and released, the panic mode will be turned off
immediately.
4. If the button is not pressed, the alarm will automatically stop after 60 seconds.
N. TRIGGER THE SYSTEM
When armed, your vehicle is protected as follows:
1.Light impacts will trigger the warn-away signal. A [3] long chirp from siren/horn.
2.Heavy impacts / Doors open / Hood open / Trunk open / Turn on the ignition key will trigger the programmed
sequence.
The starter disable relay (if installed) prevents the vehicle’s starter from cranking. The siren, horn, parking lights,
and dome light will turn on to alerting of an intrusion for 60 seconds. Then it will stop and automatic reset and
re-arm. If the one of sensors or detectors still active, the alarm system will sound a maximum of 3 times of 60
seconds cycles.
K. DOME LIGHT CONVENIENCE DELAY & SUPERVISION (See Alarm Feature III – 2
Programming)
The alarm with a unique feature which will turn on your vehicle dome light as following:
1.Upon disarming, the interior lights will remain on for 30 seconds.
2.If the vehicle is intruded, the interior light will flash for the same duration as the siren.
Note: Turn on the ignition switch or arm the alarm will turn off the dome light.
L. IGNITION CONTROL DOOR LOCKS. (See Alarm Feature II – 2 Programming).
If the vehicles door locks have been interfaced to the security system, the system will automatically lock the
vehicle's doors when the ignition is turned “ON” and /or unlock the vehicle’s doors when the ignition is turned
“OFF”.
M. TRUNK RELEASE
Press and hold the button on transmitter for two seconds to remote control the trunk release or other
electric devices.
.
REMOTE START OPERATION:
WARNINGS:
As with any product that performs automatic functions, there are certain safety precautions that you must
practice and be aware of.
1. Keep the transmitter out of children’s reach.
2. Do not leave anyone in the vehicle while running on remote control.
3. Alert servicing personnel that the vehicle can be started automatically.
4. Do not start the vehicle by remote while it’s in an enclosed area or garage.
5. Always apply the parking brake and lock the vehicle as you exit the vehicle.
6. The vehicle windows must be rolled up.
7. Should the unit malfunction, disconnect the fuse until the problem is corrected.
8. The use and operations of this system is the sole responsibility of the operator.
9. Some areas may have local ordinances that prohibit leaving a vehicle running on public streets.
10. Do not start the vehicle by remote while the standard transmission vehicle is parked at a steep place.
A. TO REMOTE START THE VEHICLE:
When you want to start your vehicle,
1. Press button twice on the transmitter.