User's Manual

ZTH100 Operating Instructions

060902

HomePro

by ADVANCED CONTROL TECHNOLOGIES, INC.

If a module button is pressed you will get:

depending on which of the two options you selected.

4.5 BURGLAR DETERRENT

When in burglar deterrent mode the remote will randomly turn module on and off in the time interval set by the user

in the “customize time” menu. By default no modules are included in the burglar deterrent mode. So the first step

the user should perform, is to include the units that should be used during burglar deterrent. See section 4.5.3 for

information about how to include units in burglar deterrent.

The following issues should be noted:

1. When the burglar deterrent period expires or is exited by the user, the remote will turn off all the modules

it currently has marked as activated. This may include units that already were ON before burglar deter-

rent was started.

2. Because of the randomness involved the actual start time when burglar deterrent activates the first

module will vary from the start time with +/-15 minutes.

3. After burglar deterrent has activated the first module it will make sure that at least one module is on

during the burglar deterrent period.

4. If only one module is included in burglar deterrent this module will be turned on when burglar deterrent

activates the first time and not be turned off until burglar deterrent ends. Refer to paragraph 3.

5. When the end time is reached it will take from 0 to 59 minutes before it turns off the modules it activated.

6. Burglar deterrent information is only stored in the remote.