Owners manual

HEININGER HOLDINGS, LLC
Makers of Advantage® Sports Rack, HitchMate® Cargo Products,
CommuteMate™ Travel Enhancements, GarageMate® Organization/Tools Products
2222 Queen Street, Bellingham, WA 98229-4753 USA
www.heininger.biz
E-Mail: [e-mail]
Phone: [phone], Fax: [phone],
At this point the BedRack™ is fully assembled. Now you are ready to install the rack into your pick-up.
1. Set the BedRack™ in the bed of the pick-up with side adjustments close to the cab
2. Tighten the side adjustments against the bed wall until they are snug and secure. Then tighten the
outside wing nut securing the side adjustments in place.
3. Place up to 4 bikes in the BedRack™ with the rear wheel in the rack. Loosen the wheel tensioner
so that the rear bike tire can be fully inserted into the BedRack™. Slide the wheel tensioner snug
against the rear wheel and tighten the fastening thumb screw on the side. Should look like picture
below. Repeat for each bike.
4. Press the foam wheel stabilizers against the rims to keep give the wheel a snug fit.
5. Secure bicycles using enclosed locking cable by looping the cable through the bike frame(s) and
BedrRack™, then attach the pad lock to the end-loops.
Also use the BedRack™ as a bike rack when camping. Now you don’t have to lay your bikes up against a
tree, vehicle or lay them on the ground.
If you have questions on how to assemble the BedRack please call
1-888-722-5240.
Hours of operation 8-5PM M-F PST.