Installation Guide

ManualsBrandsAdvanTech ManualsConstruction AdhesiveS-20011PC

Installation Guide

CONTENTS

2 What is AdvanTech

™

Subﬂoor Adhesive?

2 AdvanTech Subﬂoor Adhesive Advantages

2 Coverage Rates

3 AdvanTech Subﬂoor Adhesive Safe Use and Handling

3 AdvanTech Subﬂoor Adhesive First Aid

3 Storage, Handling and Disposal

4 Adhesive Can Attachment and Changeover

4 - 5 AdvanTech Subﬂoor Adhesive Installation / Application

6 AdvanTech Subﬂoor Adhesive Cleanup

6 Troubleshooting

ATTENTION: This installation guide is intended to provide general information for the designer and end user. The following guidelines will help

you properly apply AdvanTech™ subﬂoor adhesive. We urge anyone installing this product to read these guidelines in order to minimize any risk of

safety hazards and to prevent voiding any applicable warranties. This manual is a general installation guide and does not cover every installation

condition. Proper installation shall be deemed to mean the most restrictive requirement speciﬁed by Huber Engineered Woods (HEW), local building

code, engineer or architect of record or other authority having jurisdiction. You are fully and solely responsible for all safety requirements and code

compliance. For additional information, contact Huber Engineered Woods LLC.

SUBFLOOR ADHESIVE

Summary of content (8 pages)

PAGE 1
SUBFLOOR ADHESIVE Installation Guide CONTENTS 2 2 2 3 3 3 4 4 - 5 6 6 What is AdvanTech™ Subfloor Adhesive? AdvanTech Subfloor Adhesive Advantages Coverage Rates AdvanTech Subfloor Adhesive Safe Use and Handling AdvanTech Subfloor Adhesive First Aid Storage, Handling and Disposal Adhesive Can Attachment and Changeover AdvanTech Subfloor Adhesive Installation / Application AdvanTech Subfloor Adhesive Cleanup Troubleshooting ATTENTION: This installation guide is intended to provide ge
PAGE 2
AdvanTech™ Subfloor Adhesive // Installation Guide What is AdvanTech™ Subfloor Adhesive? AdvanTech™ subfloor adhesive is a high-performance, moisture-cured, gun-applied polyurethane construction adhesive that can be used in cold and wet weather conditions. It easily dispenses as a foam bead that quickly condenses to form a high-strength gel adhesive.
PAGE 3
AdvanTech™ Subfloor Adhesive // Installation Guide 3 AdvanTech™ Subfloor Adhesive Safe Use and Handling - Important – Read all directions and cautions before use. Refer to product Safety Data Sheet (SDS) prior to handling or using AdvanTech™ subfloor adhesive. - Always wear proper personal protective equipment including gloves, clothing and eye protection. Wash hands thoroughly after handling. - Do not store in hot vehicle, direct sunlight or temperatures exceeding 122º F (50º C).
PAGE 4
AdvanTech™ Subfloor Adhesive // Installation Guide Adhesive Can Attachment and Changeover Basket - APPLICATOR GUN: - ATTACHMENT TO GUN: Ensure control knob is in the closed position (all the way right/clockwise.) Place threaded end of container into applicator gun basket and rotate in a clockwise direction until tight. Do not over-tighten. Tip Control Knob Barrel Trigger Handle - PREPARING ADHESIVE: Shake can vigorously for minimum 30 seconds.
PAGE 5
AdvanTech™ Subfloor Adhesive // Installation Guide 5 Open control knob (left/counter-clockwise) and test a bead of adhesive. Bead width can be adjusted by opening/closing the control knob or adjusting the trigger pull back. Adjust these two factors to your desired application approach, until you get a ½" foam bead.
PAGE 6
AdvanTech™ Subfloor Adhesive // Installation Guide AdvanTech™ Subfloor Adhesive Cleanup AdvanTech™ polyurethane foam cleaner cleans wet foam from hands, tools and applicator guns. It can attach directly to the applicator gun and spray right from the can to clean the inside of the gun. With partially used cans of adhesive, keep the gun attached and close the control knob. Wipe gun tip with rag at the end of each use or spray tip with AdvanTech polyurethane foam cleaner to prolong applicator gun life.
PAGE 7
AdvanTech™ Subfloor Adhesive // Installation Guide NOTES 7
PAGE 8
AdvanTech™ Subfloor Adhesive Installation Guide © 2015 Huber Engineered Woods LLC. AdvanTech, the AdvanTech logo and design are trademarks of Huber Engineered Woods LLC.